2.2.2 Mold cooling system The original mold cooling system was a “U” type. The circuit was distributed in more critical plates and/or mold components. Plate 2 contains two pairs of more centralized, ...

PCS company expands heated sprue bushing line.The company notes that process hold time is reduced by the formation of a small gate stub on the part or runner, which does not subsequently increase the ...

I-Mold’s innovative Gate Cutter automates the removal of sprues and runner channels directly within the closed mould, eliminating the need for manual post-processing. Compatible with various gate ...

At Fakuma 2024, taking place from 15 to 19 October in Friedrichshafen, Germany, Oerlikon HRSflow will showcase its cutting-edge hot runner technologies designed to enhance sustainability and ...

The electric system will allow you to close the mold to a precise position with an accuracy of less than 0.001″, begin the injection sequence, and then continue mold closing with precise closing ...

At Fakuma, Mold-Masters will showcase its latest products including new hot runner systems, temperature and motion controllers, an auxiliary injection unit, a gate seal and sustainable processing ...

Automated Assemblies' Express 3000 system consists of a sprue picker, granulator and hopper loader and is designed to provide molders with a closed-loop material recovery system for less than $13,000.

Off-centre gates are the bane of stretch blow molding. When the injection gate of the preform ends up away from the centre of the bottle, the wall further from the gate becomes thinner and the one ...

Abstract Although computer-aided engineering (CAE) software has been used for many years in the plastic industry, identifying the most appropriate mesh geometry and density remains a challenge. It can ...